Dryer Heating Element Replacement in Warsaw
Dryer starts, drum turns, but clothes are still wet? Air is blowing, but it’s not warm? Most likely the heating element has failed — this part warms the air before it goes into the drum. It’s one of the most frequent dryer problems. We replace heating elements on site across Warsaw — multimeter check and installation done in one visit.
Cost
The price depends on the model and the wattage of the element. Prices are shown in the table. Diagnostics are included, element billed separately.
| Service | min | max |
|---|---|---|
| Belt replacement (dryer) | 300 zł | 350 zł |
| Rollers / bearings replacement (dryer) | 350 zł | 500 zł |
| Heating element replacement (dryer) | 350 zł | 450 zł |
| Fan replacement (dryer) | 300 zł | 400 zł |
| Condensate pump replacement (dryer) | 300 zł | 400 zł |
| Control module repair (dryer) | 450 zł | 600 zł |
How it works
- You explain the issue — wet laundry, cold air, overheating error.
- The technician arrives with the element.
- We disconnect the dryer and remove the rear panel.
- We test the element with a multimeter — open circuit or short to the casing.
- We disconnect it, remove the old part, and install the new one.
- We also inspect the thermal fuse and thermostat (they often go bad together).
- We put everything back together and test — hot air returns, laundry dries.
Mistakes
- Mixing it up with a clogged filter — the filter is clean, but there is still no heat.
- Skipping the thermal fuse check during element replacement.
- Installing an element with the wrong wattage.
- Using the dryer with no heat — just wasting electricity.
- Not cleaning the duct — a blocked duct caused the burnout.
Preparation
- Dryer model.
- Describe the problem: cold air, error, wet laundry.
- Unplug the dryer.
- Access from the rear.
- Photo of the model.
- Clean the lint filter.
- Stacked? Tell us in advance.
- Towel.
Case from Warsaw
Client in Żoliborz: Electrolux — drum turning, fan working, but laundry still wet after an hour. The element had an open circuit, and the thermal fuse was also blown (one-shot type). We replaced both. The air duct was 70% clogged with lint — that was the real cause. Cleaned it. Test run — laundry dry in 50 min. One hour. Tip: if the element burns out, always inspect the duct too — otherwise the new element can overheat as well.
FAQ
How to tell?
Drum turns, air is cold, laundry stays wet.
Thermal fuse?
Safety part that cuts the circuit if the dryer overheats. Check it when replacing the element.
Why does it burn out?
Blocked duct → weak airflow → overheating. Or simple wear over time (5–10 years).
Brings element?
Yes.
Time?
45 min – 1.5 hours.
Dry without element?
Cold-dry mode — 3–4x slower.
DIY?
No — 220V.
Brands?
Bosch, Samsung, LG, Electrolux, Beko, Whirlpool, AEG.
Duct cleaning?
Once a year. We clean it during element replacement.
Who does the work
Heating element replacement done by dryer repair specialists. We cover all of Warsaw. No heat? Call us.