Dryer Rollers and Bearings Replacement in Warsaw
Dryer squeaking, banging, or is the drum scraping the housing? The drum runs on support rollers or bearings, and these parts wear out with use. We replace them on site all over Warsaw — getting the dryer back to quiet running in a single visit.
Cost
The price varies by model. Current rates are shown in the table. Parts are billed separately.
| Service | min | max |
|---|---|---|
| Belt replacement (dryer) | 300 zł | 350 zł |
| Rollers / bearings replacement (dryer) | 350 zł | 500 zł |
| Heating element replacement (dryer) | 350 zł | 450 zł |
| Fan replacement (dryer) | 300 zł | 400 zł |
| Condensate pump replacement (dryer) | 300 zł | 400 zł |
| Control module repair (dryer) | 450 zł | 600 zł |
How it works
- You tell us what’s happening — squeaking, thumping, scraping.
- The technician checks the model and the drum support system.
- Power off, panel removed.
- Belt off, drum taken out.
- Rollers/bearings checked.
- They are replaced as a full set (recommended).
- Everything goes back together, then we test — smooth and quiet.
Mistakes
- Changing just one roller.
- Brushing off thumping noises.
- Adding lubricant instead of fitting new parts.
- Skipping the seal check on models with a rear bearing.
- Running the dryer on worn rollers — the drum gets scratched.
Preparation
- Dryer model.
- Say what you hear: squeak, thump, and when it happens.
- Unplug the dryer.
- Make sure there is access from the front and rear.
- Photo of the model label.
- Take out the laundry.
- Stacked? Tell us in advance.
- Put a towel on the floor.
Case from Warsaw
Client in Praga-Południe: Samsung — sharp squeal on every turn. Both front support rollers were badly worn, and the plastic had split. The drum had sagged and was rubbing on the front panel. We replaced both rollers and the belt tensioner. Quiet again, drum sitting level. 1.5 hours. Tip: once squeaking begins, don’t wait — worn rollers cut grooves into the drum surface.
FAQ
What are support rollers?
Plastic or rubber wheels that carry the drum. Usually 2–4.
Why do they wear?
Friction, heat, and the weight of wet laundry. Around 5–8 years in many cases.
Replace all or just one?
All — they tend to wear at a similar rate.
Thumping = rollers?
Often yes. It can also be a foreign object or a loose counterweight.
Brings parts?
Yes.
Time?
1–2 hours (the drum needs to come out).
Brands?
Bosch, Siemens, Samsung, LG, Electrolux, Beko, Whirlpool.
Dangerous to keep using?
Not dangerous, but the drum will get scratched more quickly.
Bearings?
Some dryers have bearings instead of rollers.
Who does the work
Roller and bearing replacement done by dryer repair specialists. We cover all of Warsaw. Squeaking? Give us a call.