How much does oven control module repair cost in Warsaw?
The price depends on the model and how involved the repair is. Up-to-date prices are in the table. If repairing the components isn’t possible, they’ll arrange a new module.
| Service | Price |
|---|---|
| Heating element top/bottom replacement (oven) | 250–350 zł |
| Thermostat replacement (oven) | 250–420 zł |
| Fan replacement (oven) | 300–400 zł |
| Mode selector switch replacement (oven) | 300–400 zł |
| Door glass replacement (oven) | 300–400 zł |
| Control module repair (oven) | 250–550 zł |
Indicative prices. Ranges for a typical scope. Fixings included, materials separate. Minimum order 300 zł.
Price ranges and offers from tradespeople: home repair service in Warsaw.
How oven control module repair is done
- You say so in the order what the oven is doing.
- The technician checks the model.
- Tradespeople disconnect the oven, pull it out, and remove the board.
- Visual check: swollen capacitors, overheating marks, burnt traces.
- Parts are tested with a multimeter and oscilloscope.
- Defective parts are resoldered or replaced: relays, capacitors, transistors, ICs.
- The board goes back in, then they test all modes and functions.
Mistakes
- Buying a new module straight away: often replacing a few components is enough.
- Clearing errors by unplugging the oven: the actual fault stays.
- Buying used boards — their condition is unknown.
- No surge protection: one of the main reasons boards fail.
- DIY repair: capacitors keep charge even after disconnection.
Preparation
- Oven model.
- Error code if displayed.
- Description of the problem.
- Disconnect from mains.
- Make space to pull the oven out.
- Photo of the model.
- Any recent power surges?
- Socket available for testing.
A real case from Warsaw: oven control module repair
Client in Bielany: Bosch oven went dead after a power cut: no display, no reaction. Tradespeople removed the board and found two swollen 470µF electrolytic capacitors and a burnt voltage regulator IC. All three parts were replaced. The display came back and every mode worked properly. The repair took around 1.5 hours: far cheaper than a new module. Tip: after a power outage, wait a few minutes before turning appliances back on.
FAQ
What’s repairable?
Capacitors, relays, transistors, voltage regulators, microcontrollers, connectors, traces. 70% can be repaired at component level.
Dark display?
Most often it’s the module, a blown regulator or fuse.
Can it be reflashed?
Yes, if the firmware is corrupted.
DIY safe?
No — capacitors hold charge, 220V is present.
Time?
1–3 hours. In some cases the board is taken to the workshop.
Repair or new oven?
Repair makes sense if it’s under 10 years old.
Brings parts?
Yes.
Brands?
Bosch, Siemens, Electrolux, Samsung, Beko, Amica, Whirlpool, Gorenje.
Protection?
A surge protector or stabiliser on the circuit.
Who does the work
Control module repairs are done by technicians with hands-on experience in appliance electronics. Tradespeople work across Warsaw with proper soldering stations. Oven not working? Add to the order a message.
Order in the app
Describe the job, add photos and the address. Tradespeople send their own prices and dates, and you pick one of the offers.
Open the app
