Oven repair in Warsaw — Bosch, Electrolux, Amica
The oven does not heat, trips the breaker as soon as you turn it on, the convection fan is no longer running, or an error code appears on the display. Rather than spending a week eating food from the microwave, call a technician. We fix Bosch, Electrolux, Amica and other brands all over Warsaw — from Mokotow to Bielany.
Important: an oven is wired into a high-load electrical circuit. Before any repair, turn off the breaker at the consumer unit — not only the oven’s power button. Do not try to take off the rear panel or change a heating element on your own — there may still be residual voltage. Our technician works only on appliances that are fully disconnected from power.
How much does oven repair cost
You can find current prices in the table below. The final amount depends on the brand, the kind of fault, and whether any parts have to be replaced. Diagnostics are part of the repair price. Spare parts are billed separately.
| Service | min | max |
|---|---|---|
| Heating element top/bottom replacement (oven) | 250 zł | 350 zł |
| Thermostat replacement (oven) | 250 zł | 320 zł |
| Fan replacement (oven) | 300 zł | 400 zł |
| Mode selector switch replacement (oven) | 300 zł | 400 zł |
| Door glass replacement (oven) | 300 zł | 400 zł |
| Control module repair (oven) | 400 zł | 550 zł |
How the home repair works
- You explain the issue: no heating, breaker tripping, one mode not working, error on the display.
- The technician checks the model and brand — asks you to send a photo of the data plate.
- We set a time — often the same day or the next.
- At the visit, the technician turns off the breaker and checks that there is no voltage.
- Diagnostics: heating elements (top, bottom, grill), thermostat, convection fan, control board, door seal.
- If the part is available — repair is done straight away. If not — we order it and arrange a return visit.
- After the repair, the oven is powered on, heated to working temperature, and every mode is checked.
Common oven owner mistakes
- Using the oven with a torn door seal — heat gets out, the element works harder, and power use goes up.
- Cleaning with abrasive products — this scratches the enamel, which later starts to rust and peel.
- Using pyrolytic cleaning too often — at 500°C the seals wear out and the contacts overheat.
- Ignoring a loud or slow convection fan — the bearing wears down and the fan locks up.
- Connecting the oven to a regular socket without a dedicated circuit — the cable overheats and the breaker trips.
- Trying to replace an element yourself — wrong wiring may lead to a short circuit.
What to prepare before the technician arrives
- Write down the error code from the display (if any).
- Take a photo of the data plate with the model and serial number.
- Turn off the breaker at the consumer unit (not just the oven button).
- Allow the oven to cool completely.
- Take out trays, racks, and any thermometer.
- Make sure there is access — if it is built-in, check whether it can slide out.
- Note when the problem began: after a power surge, after cleaning, or gradually.
- Check whether the oven has a dedicated circuit with its own breaker.
- Give access details: intercom code, parking info.
- Group all appliance jobs into one visit.
A real case from Warsaw
A client in Praga Poludnie said their built-in Electrolux oven had stopped heating — the display was working, modes changed normally, but the temperature did not go up. Diagnostics showed that the bottom heating element had burned out — the break could be seen clearly. The top element and grill were in good shape. The technician replaced the lower heater (the part was on hand), checked the thermostat, and heated the oven to 200°C — it reached temperature in 8 minutes, in line with specification. The whole repair took 50 minutes. Conclusion: if the oven heats unevenly, one element has probably failed — not the entire system.
Frequently asked questions
Which oven brands do you repair?
Bosch, Electrolux, Amica, Siemens, Samsung, Beko, Whirlpool, AEG and others.
Is the diagnostic fee separate?
It is included in the repair price. If you decide not to proceed, you pay only for the call-out.
How long does the repair take?
Replacing an element or thermostat — around an hour. Board or fan — up to 2 hours.
Why does the oven trip the breaker?
An element-to-earth fault, damaged wiring, or a faulty control board. The circuit breaker itself may also be too small.
Can a built-in oven be repaired in place?
Yes, in most cases it can be pulled out from its housing without removing it fully.
Is it worth repairing an oven over 10 years old?
If the repair costs more than 50% of a new oven’s price, replacement makes more sense.
Do you bring spare parts?
Heating elements, thermostats, and door seals are often in stock. Boards and fans are ordered.
What if the oven is smoking?
Turn off the breaker. Possible causes include food residue on the element, damaged cable insulation, or overheating.
How quickly can you come?
Often the same day or the next. Urgent call-outs have a surcharge.
Who does the work
Oven repairs are done by technicians with hands-on experience in built-in kitchen appliances. We work across all of Warsaw. Call or message us — we will work out the fault and come at a time that suits you.