Roller Blind and Shutter Repair in Warsaw — Mechanism Restoration in One Visit
Roller Blind and Shutter Repair in Warsaw — Mechanism Fix in One Visit
The shutter won’t lift, the blind has stuck, the strap drive has broken, or the cord has come off the reel — know the situation? External roller shutters are installed on almost every window in Warsaw, and day-night blinds are found in nearly every bedroom. Sooner or later the mechanism wears down, but changing the whole unit is often unnecessary. We repair roller shutters and blinds throughout Warsaw: from flats in Ursynow to houses in Bemowo. We inspect, repair or replace the mechanism — and the window works properly again.
How much does it cost and what affects the price
The price depends on the kind of fault and the shutter construction. Changing a strap drive belt costs one amount. Fixing a spring mechanism costs another. Replacing the motor in an electric shutter is the most involved job. The final price is affected by whether the housing has to be removed, the mechanism type (strap, cord, electric), and access to the window (height, balcony). Fixings are included; spare parts are billed separately if required. You can check current prices in the table below.
| Service | min | max |
|---|---|---|
| Roller blind / venetian blind repair | 150 zł | 350 zł |
| Roller blind cord / mechanism replacement | 120 zł | 250 zł |
How the repair works
- You explain the issue and send a photo — the technician works out the construction type.
- We set a time — often the same day or the next.
- At the property, the technician opens the inspection hatch or removes the housing to locate the fault.
- The repair is done: strap replacement, cord rewinding, spring adjustment, limit-switch replacement.
- If a needed part is not available on hand — it is ordered and we come back.
- Operation is checked: the shutter goes up and down smoothly, locking at every position.
- The housing is put back together and checked for a proper seal.
Common DIY repair mistakes
- Forcing a stuck shutter — which cracks slats or rips the strap off the drum.
- Opening the housing without securing the spring — the mechanism snaps back hard.
- Installing a replacement strap with the wrong width — it won’t run through the guide roller.
- Taking apart day-night blinds without photographing the order — then they won’t go back together properly.
- Spraying the mechanism with WD-40 — it’s a solvent, not a lubricant; after a month the problem gets worse.
- Trying to repair an electric drive without electrical knowledge — risk of short circuit.
What to prepare before the technician arrives
- Take a photo of the shutter both closed and open — and of the place where it got stuck.
- Check the drive type: strap (belt on the side), cord (chain/cord), electric (wall switch).
- For electric shutters — make sure there is power at the switch.
- Free up access to the window — move plants, curtains, and furniture from the sill.
- If the inspection hatch is outside (balcony or facade) — provide access.
- Write down the shutter model or installation year — this makes parts sourcing easier.
- Give the intercom code and parking details.
- If more than one window has a problem — tell us beforehand.
A real case from Warsaw
A visit to a flat in Ursynow: the external shutter on the balcony door would not lift. Strap drive — the belt was hanging slack and not winding back. We opened the inspection hatch and found that the drum spring had weakened and was no longer keeping tension. We tightened the spring again and replaced the worn strap (old one 23 mm, new one the same size). Tested it — the shutter lifts and locks smoothly, without jerking. The full job took about 40 minutes. The client was ready to replace the whole shutter — but in the end it only needed a new strap and a spring adjustment.
Frequently asked questions
Which types of shutters do you repair?
All external roller shutters: strap, cord, and electric. Also day-night blinds and internal roller blinds.
Can you repair a broken strap?
Yes, we fit a new one. This is one of the most common faults — fixed in 20-30 minutes.
The shutter goes up but does not stay in place — what is wrong?
Most likely the drum spring has weakened. We adjust the tension and the locking works again.
Do you repair electric shutters?
Yes. We check the power, limit switches, and motor. If the motor is burnt out, we replace it with a compatible unit.
How long does a repair take?
Strap replacement — 20-30 minutes. Spring adjustment — 30-40 minutes. Motor replacement — 1-2 hours.
Do I need to order parts in advance?
Standard straps and cords are carried by the technician. Motors and non-standard parts are ordered separately.
What is included in the price?
The technician’s labour, diagnostics, and basic fixings. Spare parts (strap, motor, cord) are charged separately.
Do you repair day-night blinds?
Yes. Common problems: fabric out of line, stuck mechanism, broken cord. All of this can be repaired.
Do you work on weekends?
Yes, Saturday and Sunday are normal working days.
Who does the repair
Shutters and blinds are repaired by a technician with hands-on experience in window-system mechanisms. He knows the designs used by Velux, Fakro, Aluprof, KRISPOL, and other manufacturers popular in Poland. We work across all of Warsaw. Call or message us — we answer within an hour.