Washing Machine Shock Absorber Replacement in Warsaw
Is your washer shaking hard, hopping during spin, thumping, or creeping across the floor? Shock absorbers are there to calm drum movement. Once they wear out, the drum starts swinging loose and knocks into the cabinet. That’s more than just noise — vibration ruins bearings and can tear up hoses and wiring. We change absorbers on site anywhere in Warsaw — around an hour of work.
Cost
They are always changed in pairs. Prices are in the table. Parts are billed separately.
| Service | min | max |
|---|---|---|
| Drain pump replacement (washing machine) | 250 zł | 350 zł |
| Heating element replacement (washing machine) | 250 zł | 320 zł |
| Water inlet valve replacement (washing machine) | 250 zł | 300 zł |
| Shock absorber replacement (washing machine) | 300 zł | 400 zł |
| Belt replacement (washing machine) | 250 zł | 300 zł |
| Bearing replacement (washing machine) | 550 zł | 660 zł |
| Door lock replacement (washing machine) | 250 zł | 300 zł |
| Control module repair (washing machine) | 400 zł | 550 zł |
How it works
- You explain the problem — vibration, jumping, banging during spin.
- The technician checks the model.
- Disconnect the machine, remove the front or rear panel.
- Inspect the absorbers — press them by hand. No resistance = worn out.
- Take out both (fixed to the base and drum).
- Install a new pair.
- Run a test at 1000+ rpm spin — vibration should be minimal.
Mistakes
- Changing just one.
- Mixing it up with an unleveled machine.
- Keep washing with heavy vibration — destroys bearings.
- Skipping a check of the suspension springs.
- Leaving transit bolts in place (new machine).
Preparation
- Washer model.
- Say what happens: vibration, jumping, and when.
- Unplug it.
- Access from the front.
- Towel.
- Photo of the model.
- Level? (rock it by hand)
- Built-in? Tell us.
Case from Warsaw
Client in Ursynów: Bosch was jumping at 1200 rpm — shifting 10 cm each cycle. Both absorbers had no resistance at all — the oil had leaked out. We replaced the pair. Test at 1400 — barely any vibration, machine stays put. 50 min. Tip: if your washer suddenly starts jumping, check the absorbers first instead of putting a rubber mat underneath.
FAQ
What do absorbers do?
They reduce drum vibration. Without them, the drum bangs into the casing.
Replace one or both?
Always both.
Could be something else?
An unleveled machine, transit bolts, or worn springs.
Dangerous to keep using?
Yes — bearings, hoses, and wiring get damaged.
Brings?
Yes.
Time?
45 min – 1.5 hours.
Brands?
Bosch, Samsung, LG, Electrolux, Beko, Whirlpool, Indesit.
How long do they last?
5–8 years.
Transit bolts?
If the machine is new and jumping — check 3–4 bolts on the back.
Who does the work
Shock absorber replacement done by washer repair specialists. We cover all of Warsaw. Machine jumping? Call us.