Washing Machine Water Inlet Valve Replacement in Warsaw
Is your washer not taking in water, filling very slowly, or letting water into the drum even when it’s turned off? The inlet valve is an electrically controlled tap that opens when the control board tells it to. If the diaphragm is worn out or the coil has burned out, the valve may stop opening or stop shutting properly. We replace inlet valves on site all over Warsaw.
Cost
The part itself is cheap. Prices are in the table. Valve billed separately.
| Service | min | max |
|---|---|---|
| Drain pump replacement (washing machine) | 250 zł | 350 zł |
| Heating element replacement (washing machine) | 250 zł | 320 zł |
| Water inlet valve replacement (washing machine) | 250 zł | 300 zł |
| Shock absorber replacement (washing machine) | 300 zł | 400 zł |
| Belt replacement (washing machine) | 250 zł | 300 zł |
| Bearing replacement (washing machine) | 550 zł | 660 zł |
| Door lock replacement (washing machine) | 250 zł | 300 zł |
| Control module repair (washing machine) | 400 zł | 550 zł |
How it works
- You explain the issue — no water coming in, nonstop filling, error.
- The technician checks the model.
- Shut off water, unplug the machine.
- Take off the top cover — the valve sits at the rear top with the supply hose connected.
- Check the coil with a multimeter — it should show 2–4 kΩ.
- Remove hoses and connector, install the new valve.
- Turn the water back on, test — fast fill, no drips, stops after filling.
Mistakes
- Skipping the tap check — it might simply be shut.
- Mixing it up with a blocked inlet mesh filter.
- Missing constant filling — risk of flooding.
- Ordering a valve with the wrong number of sections (single/double/triple).
- Not testing the wiring from the board to the valve.
Preparation
- Washer model.
- Tell us: no fill, constant fill, error.
- Close the water supply tap.
- Unplug the machine.
- Access to the rear top.
- Towel — some water will come out when hoses are disconnected.
- Photo of the model.
- Installed under the counter? Tell us.
Case from Warsaw
Customer in Ochota: LG — did not fill, showing IE error. Tap was open, water pressure was good. The valve coil was burned out (open circuit). We replaced the double valve. Test — fills in 3 minutes, no leaks. 30 minutes. Tip: if the washer does not fill, first check the tap and clean the inlet mesh — that fixes 20% of cases at no cost.
FAQ
What does the valve do?
It’s an электромagnetic tap — opens and closes the water supply when the board tells it to.
No fill = valve?
It could also be the tap, mesh filter, or wiring.
Water running constantly?
Likely a damaged diaphragm — shut off the tap right away.
Brings valve?
Yes.
Time?
20–40 min.
Brands?
Bosch, Samsung, LG, Electrolux, Beko, Whirlpool, Indesit.
Valve types?
Single, double, or triple — each feeds different dispenser sections.
Clean mesh myself?
Undo the hose at the back, pull the mesh out with pliers, rinse it.
Dangerous?
Yes — it can flood the place. Turn off the tap immediately.
Who does the work
Inlet valve replacement done by washing machine repair specialists. We cover all of Warsaw. Washer not filling? Call us.