Washing Machine Water Inlet Valve Replacement in Warsaw
26.03.2026Washing Machine Water Inlet Valve Replacement in Warsaw
Washer not filling, filling too slowly, or water pouring into the drum even when switched off? The inlet valve is a solenoid-operated tap that opens on command from the control board. When the diaphragm wears or the coil burns out, the valve either won’t open or won’t close. We replace inlet valves on site across Warsaw.
Cost
Inexpensive part. Prices in the table. Valve charged separately.
| Service | min | max |
|---|---|---|
| Drain pump replacement (washing machine) | 250 zł | 350 zł |
| Heating element replacement (washing machine) | 250 zł | 320 zł |
| Water inlet valve replacement (washing machine) | 250 zł | 300 zł |
| Shock absorber replacement (washing machine) | 300 zł | 400 zł |
| Belt replacement (washing machine) | 250 zł | 300 zł |
| Bearing replacement (washing machine) | 550 zł | 660 zł |
| Door lock replacement (washing machine) | 250 zł | 300 zł |
| Control module repair (washing machine) | 400 zł | 550 zł |
How it works
- You describe — no fill, constant fill, error.
- Technician identifies model.
- Turn off water, unplug.
- Remove top cover — valve at back top, supply hose attached.
- Test coil with multimeter — should read 2–4 kΩ.
- Disconnect hoses and plug, fit new valve.
- Turn on water, test — fills quickly, no drips, shuts off after fill.
Mistakes
- Not checking the tap — it may just be closed.
- Confusing with a clogged inlet mesh filter.
- Not noticing constant filling — flood risk.
- Buying a valve with the wrong number of sections (single/double/triple).
- Not checking wiring from board to valve.
Preparation
- Washer model.
- Describe: no fill, constant fill, error.
- Turn off water supply tap.
- Unplug.
- Rear top access.
- Towel — water when disconnecting hoses.
- Photo of model.
- Under counter? Let us know.
Case from Warsaw
Client in Ochota: LG — wouldn’t fill, error IE. Tap open, pressure fine. Valve coil burned out (open circuit). Replaced double valve. Test — fills in 3 minutes, no leaks. 30 minutes. Tip: if the washer won’t fill, first check the tap and clean the inlet mesh — solves 20% of cases for free.
FAQ
What does the valve do?
Solenoid tap — opens/closes water supply on board command.
No fill = valve?
Could be tap, mesh filter or wiring.
Water running constantly?
Damaged diaphragm — turn off tap immediately.
Brings valve?
Yes.
Time?
20–40 min.
Brands?
Bosch, Samsung, LG, Electrolux, Beko, Whirlpool, Indesit.
Valve types?
Single, double or triple — feeds different dispenser compartments.
Clean mesh myself?
Disconnect hose at back, pull out mesh with pliers, rinse.
Dangerous?
Yes — flooding. Turn off tap immediately.
Warranty?
Yes.
Who does the work
Inlet valve replacements by washer specialists. All of Warsaw. Won’t fill? Call us.