Repair after flooding in a Warsaw apartment: floors, doors and drying

How much repair after flooding costs and what the price depends on

The price depends first of all on how far the water travelled and whether it got underneath the floor. A puddle covering two metres of hallway is one job; water that ran under the thresholds into two rooms is another. The second factor is the floor type: click panels can sometimes be lifted and relaid, while glued vinyl and parquet rarely forgive that treatment. The third is time: the longer the floor stayed closed with water underneath, the more likely it is that drying, underlay replacement and work along the bottom of the walls get added. Some items are replaced after any flood regardless of the rest: underlay, MDF skirting boards and thresholds in doorways. Current rates for each job are in the table below.

Rebuilding the finish is quoted separately, because it belongs to a different stage and a different moment — filling and skim coat only make sense on a dry wall. Tradespeople covered painting an apartment after a flood in a separate article, with more detail on water stains and stain-blocking primer.

The tradesperson brings fixings and small hardware. Materials: panels, underlay, skirting, thresholds, adhesive, primer, are paid separately, as are removal of wet waste and carrying materials up to the flat. Soaked underlay and cut-up skirting take far more space than people expect, so agree on waste removal in advance rather than at the end of the job.

Price ranges and offers from tradespeople: apartment finishing in Warsaw.

How the visit works: step by step

1. Tradespeople check how far the water reached, not just what is visible. A moisture meter goes over the panels, the skirting and the lower part of the wall, and they look under thresholds and behind cabinet plinths, water usually travels a few metres past the visible stain.
2. Tradespeople sort out electrical safety. The circuit in the flooded area stays off, they do not run power tools on a wet substrate, and they do not test sockets to see what happens. If water reached a back box, a socket or a ceiling fitting, an electrician assesses the wiring and decides when the circuit may be switched on again.
3. Tradespeople protect what stays in place: film over furniture, doors and appliances, skirting boards lifted and stacked in order, kitchen cabinet plinths unclipped so they can reach underneath the units.
4. Tradespeople open the floor in the wet area: panels and underlay come up, they inspect the screed and, if needed, widen the opening until they reach dry material. Panels worth reusing are marked and stood on edge to dry.
5. Tradespeople dry the structure. That means a dehumidifier and moving air, not heat turned up to maximum: a sudden rise in temperature ends with a cracked screed and warped boards. Screed dries in days rather than hours, so the date for closing the floor comes from a measurement, not from how the surface feels under your hand.
6. Tradespeople rebuild the floor: new underlay, panels with proper expansion gaps at walls and pipes, thresholds in the doorways and new skirting. Doors that swelled along the bottom get trimmed and their edge sealed, then they adjust the hinges and the strike plate — replacing the layers almost always changes the geometry of the opening.
7. What is left at the end is localised damage to the finish: filling blown patches, levelling the bottom strip of the wall or the ceiling under the leak, priming. Tradespeople clean up, walk the floor to check for creaks and level differences, and make sure every door closes.

Two things leave no room for improvisation. The first is electricity: a wet back box or a flooded light fitting is a job for an electrician, not for a hairdryer and optimism. The second is the source of the water: while it is still leaking, any repair is provisional, so the valve gets closed first, or they establish with the building management who closes it at the neighbour’s. If the flat is rented out or you are reporting the damage on a policy, take photos before anything is dismantled; once the panels are up there is nothing left to document.

Common client mistakes (and how to avoid them)

• Closing the floor over a wet screed. The surface dries first and looks ready while water stays underneath. A month later the panels swell again, this time together with the new underlay.
• Heat on maximum and a fan heater aimed at the ceiling. Fast drying warps boards and cracks screed. Slower and steadier works better: a dehumidifier plus a constant exchange of air.
• Throwing out every panel straight away. Part of the floor usually goes back down, and if the range has been discontinued that is the only way to keep the floor uniform.
• Reusing the old underlay. After a flood the underlay holds moisture and smell inside and cannot be dried back to its original state. It is the cheapest layer in the whole build-up and the wrong place to save money.
• Testing sockets in a flooded room. A damp back box looks exactly like a dry one from the outside. Until the wiring is assessed, the circuit stays off.
• Silicone or foam on a swollen door edge. That covers the symptom. The edge has to be trimmed and sealed, otherwise the material keeps drawing moisture further up the leaf.
• Putting it off. Mould starts behind the skirting and under cabinet plinths, where there is no airflow. A week of a closed wet floor is a completely different scope of work from reacting straight away.
• Pushing the furniture back the next day. A flooded area still needs airflow after the floor goes back down, and a wardrobe against the wall is the most effective way to cut it off.

If the flat has already flooded, start with the steps in flooded apartment: what to do first.

What to prepare before the visit

• Photos: the whole room, a close-up of where the floor meets the wall, and the skirting separately.
• Where the water came from and when, and whether the source is already shut off.
• Whether the flat has been dried, and for how long.
• The floor type: click panels, glued vinyl, parquet or engineered board.
• Any leftover panels and skirting from the original installation, with the range name if you have it.
• Information about underfloor heating in the flooded room.
• What you know about pipes and cables running in the floor or along the bottom of the wall.
• Clear space: furniture moved aside, cabinets emptied in the area they will be opening.
• The circuit in the flooded area switched off if water could have reached the sockets, plus a free socket outside that area for tools.
• Whether a dehumidifier is already on site or the tradesperson should bring one.
• Any inspection by the insurer or the building management: if one is still due, they leave the floor untouched until it happens.
• Who takes the wet waste away, and whether the building has a lift: removal is a separately paid item.

You do not need everything on this list.

A job from Warsaw

An apartment in Ursynów, where the supply hose to the washing machine split. Water ran under the threshold into the hallway and reached the first metre of the living room, and the owner only noticed it when he got home from work. He mopped up the puddle and left a fan running for two days; the panels looked dry and the plan was to swap a few boards near the bathroom door. The moisture meter said otherwise: readings by the wall and under the threshold were high, and once two panels came up the underlay could be wrung out by hand. Tradespeople opened the floor across the whole hallway and along the join with the living room, took out the underlay and left a dehumidifier running for four days with a reading taken once a day. Panels stood on edge dried without warping and went back down; nine boards near the threshold had to be replaced, and here the leftovers from the original installation, sitting in the basement, saved the day. The MDF skirting had swollen along the bottom and darkened, so new lengths went in, and they reworked the threshold in the doorway to the living room while they were at it. The bathroom door leaf had swollen a few millimetres at the bottom and was catching on the floor: they trimmed the lower edge, sealed it and adjusted the hinges. The blown strip of wall behind the skirting was sanded back and filled, and the owner ordered painting two weeks later, once the wall was completely dry. The whole job spread over three visits across two weeks, and what stretched it out was mostly the drying. The conclusion is simple: those four days with a dehumidifier were the cheapest part of the repair, because without them the new floor would have swollen within a month.

Frequently asked questions

Who does the work and who answers for it

The work is done by a handyman with practical experience in finishing and floor laying, not by a full-renovation crew, after a flood what matters is the order of operations and the measurements, not the number of people in the flat. Tradespeople travel across Warsaw and the nearest suburbs with tools, a moisture meter and, when agreed in advance, a dehumidifier. Materials, removal of wet waste and carrying materials up to the flat are charged separately, and they say so before they start.

The tradesperson sets out the limits of responsibility plainly. They answer for the quality of their own work: how the panels sit and their expansion gaps, the fit of skirting and thresholds, trimming and adjusting doors, and tidy execution. They do not take on the behaviour of a substrate they could not see before the floor was opened, or the consequences of someone else’s installation work: if the screed is wet deeper than can realistically be dried in a sensible time, or there is mould behind the plaster, they say so on site and propose a scope that makes sense. Electrical work after a flood and insurance matters are not theirs: the first needs an electrician, the second a loss adjuster. Post a request in the HandyMan24 app and attach photos showing how far the water reached; from those tradespeople can usually tell right away what has to be opened up and what can stay in place.