Dryer Condensate Pump Replacement in Warsaw
Condenser dryers collect moisture in a reservoir. When the pump that moves condensate into that tank stops working, water gathers inside the appliance, runs onto the floor, or the dryer shows an error and shuts down. We replace condensate pumps on site all over Warsaw — inspection and replacement in one visit.
Cost
The price depends on the dryer model. Up-to-date rates are shown in the table. Diagnostics are included, pump billed separately.
| Service | min | max |
|---|---|---|
| Belt replacement (dryer) | 300 zł | 350 zł |
| Rollers / bearings replacement (dryer) | 350 zł | 500 zł |
| Heating element replacement (dryer) | 350 zł | 450 zł |
| Fan replacement (dryer) | 300 zł | 400 zł |
| Condensate pump replacement (dryer) | 300 zł | 400 zł |
| Control module repair (dryer) | 450 zł | 600 zł |
How it works
- You tell us what’s happening — leak, error, empty tank.
- The technician arrives with the pump.
- We unplug the dryer.
- Take off the top or front panel to get to the pump.
- Check the pump — apply voltage directly, inspect the contacts.
- Fit the new pump and reconnect the hoses.
- Run a test cycle — water goes into the tank.
Mistakes
- Mistaking a bad pump for a blocked filter.
- Brushing off puddles under the dryer.
- Ordering a pump without verifying the model.
- Skipping cleaning of the hose from pump to tank.
- Keeping the dryer running without a working pump.
Preparation
- Dryer model.
- Description of the problem.
- Unplug it from the mains.
- Make sure there is clear access.
- Put a towel underneath — some leftover water may come out.
- Photo of the model sticker.
- Is the condensate tank fitted?
- Stacked on a washer? Tell us in advance.
Case from Warsaw
Client in Ursynów: a puddle under a Bosch dryer after each cycle, with the tank staying empty. The pump motor had an open winding — it wouldn’t start. We changed the pump and cleaned the hose. Test cycle was fine — water was reaching the tank. 45 minutes. Tip: if the tank is always empty but clothes come out dry, the pump is still working; if clothes stay damp and the tank is empty — the pump is dead.
FAQ
What does the condensate pump do?
It moves moisture pulled from the laundry from an internal tray into the removable tank at the top.
Why does it fail?
Motor wear, lint jamming the impeller, limescale.
Can I dry without the pump?
Only when an external drain is connected. Otherwise water ends up on the floor.
How do I know the pump has failed?
The tank stays empty after drying, there’s a puddle underneath, or a „check drain” error appears.
Does the technician bring the pump?
Yes, for common models. Rare ones — 2–5 days.
How long?
30–60 minutes.
Brands?
Bosch, Siemens, Samsung, LG, Electrolux, Beko, Whirlpool, AEG.
Expensive part?
Not a costly part.
Full disassembly needed?
No — in most cases only the top cover or front panel comes off.
Warranty?
Yes.
Who does the work
Condensate pump replacements are done by dryer repair specialists. We work across all of Warsaw. Dryer leaking? Give us a call.