How much does washing machine drain pump replacement cost in Warsaw?
The pump itself is cheap: this is one of the most frequent washer repairs. See the table for prices. Diagnostics are included, pump billed separately.
| Service | Price |
|---|---|
| Washing machine pump replacement | 180–430 zł/szt |
| Washing machine heating element replacement | 180–400 zł/szt |
| Water inlet valve replacement (washing machine) | 250–300 zł |
| Shock absorber replacement (washing machine) | 300–400 zł |
| Belt replacement (washing machine) | 250–300 zł |
| Washing machine bearing replacement | 350–800 zł/szt |
| Door lock replacement (washing machine) | 250–300 zł |
| Control module repair (washing machine) | 400–550 zł |
Indicative prices. Ranges for a typical scope. Fixings included, materials separate. Minimum order 300 zł.
What it costs and how to book: odd job man in Warsaw.
How washing machine drain pump replacement is done
- You say so in the order the symptom — not draining, buzzing, error code.
- The technician identifies the model.
- Tradespeople disconnect it from power and water.
- Residual water is drained through the filter.
- The filter is checked: if it’s clean but the pump is dead, it needs replacement.
- Tradespeople remove the lower panel or lay the machine on its side to reach it.
- Hoses and plug are disconnected, a new pump is fitted. Then they test: quick, quiet draining.
Mistakes
- Skipping the filter check first — 30% of cases turn out to be a clogged filter, not the pump.
- Mixing up a bent hose with pump failure.
- Ordering a pump with the wrong connector.
- Keeping on washing without drainage: water stays inside, then smell and mould start.
- Not inspecting the impeller for debris, a coin may jam it even when the pump itself still works.
Preparation
- Washer model.
- Describe the issue: not draining, error, buzzing.
- Unplug it and shut off the water.
- Towels, a lot of water comes out when draining the filter.
- A basin under the filter.
- Access from the front and underneath.
- A photo of the model.
- Installed under a countertop? Say so in the order in advance.
A real case from Warsaw: washing machine drain pump replacement
Client in Wola: Bosch: stopping on spin with error E18. Filter was clean, hose was clear. The pump impeller was stiff, a 50-grosz coin had jammed between the impeller and housing. Tradespeople removed the coin, but the motor was already damaged (winding overheated). Replaced the pump. Test — drained in 30 seconds, quietly. 40 minutes. Tip: always check pockets before washing: coins, pins and buttons are the #1 pump killers.
FAQ
What is the drain pump for?
It pumps water from the drum into the drain after the wash and rinse cycles.
How can I tell it has failed?
No draining, error code, buzzing while draining, water left in the drum.
Could it be something else?
A blocked filter (30%), a kinked hose, or a blocked drain pipe.
Can I check the filter myself?
Open the hatch at the bottom front, put down a basin, and unscrew the filter cap.
Do tradespeople bring the pump?
Yes.
How long does it take?
30–60 min.
Which brands?
Bosch, Samsung, LG, Electrolux, Beko, Whirlpool, Indesit, Gorenje.
Is it expensive?
No: one of the cheapest parts in a washer.
Can I wash if it won’t drain?
No — standing water leads to mould and bad smell.
Who does the work
Drain pump replacement done by washer repair specialists. Tradespeople cover all of Warsaw. Not draining?
Order in the app
Describe the job, add photos and the address. Tradespeople send their own prices and dates, and you pick one of the offers.
Open the app
